Mobile pen 8 of 17
On the front cross piece mark the center (55 1/1")
Then mark from each end of the cross piece 39 3/3" this should give you a 32" door opening.
Cut 2: 1 X 3's 68" lone, install on the 39 3/3" marks, Square it up, I use 1 5/8" coarse sheet rock screws.
When I ripped the 1 X 12 X 12's I left two boards (I am building five tractors)6" wide. Cut 1: 1 X 6 37 1/2 inches long. Screw this to the top of the door boards. Mark the center on the top of this "header" board. This mark will be used later to run a 2 X 4 front to rear as a ridge pole.
Then mark from each end of the cross piece 39 3/3" this should give you a 32" door opening.
Cut 2: 1 X 3's 68" lone, install on the 39 3/3" marks, Square it up, I use 1 5/8" coarse sheet rock screws.
When I ripped the 1 X 12 X 12's I left two boards (I am building five tractors)6" wide. Cut 1: 1 X 6 37 1/2 inches long. Screw this to the top of the door boards. Mark the center on the top of this "header" board. This mark will be used later to run a 2 X 4 front to rear as a ridge pole.
posted by Footsteps Farm | 4:35 PM
0 Comments:
Post a Comment
<< Home